FUEL PUMP > INSPECTION

for Preparation Click here

1. Check the fuel pump resistance.
   
   

   1. Using an ohmmeter, measure the resistance between terminals 4 and 5.
      

      Standard resistance:

      0.2 to 3.0 Ω at 20°C (68°F)
      

      If the result is not as specified, replace the fuel pump.
      

2. Check fuel pump operation.
   
   

   1. Apply battery voltage to terminals 4 and 5. Check that the pump operates.
      

      NOTICE:

      1. These tests must be completed within 10 seconds to prevent the coil from burning out.
         
      2. Keep the fuel pump as far away from the battery as possible.
         
      3. Always turn on and off the voltage on the battery side, not the fuel pump side.
         
      If the pump does not operate, replace the fuel pump.