CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE DRIVE BELT


    A099194E01

  1. Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the drive belt. Then remove the drive belt.

    NOTICE:
    When removing the drive belt, do not use the idle pulley's bolt.

    HINT:
    After removing the drive belt, move the tensioner upward to the maximum amount.



3. REMOVE COOLER COMPRESSOR ASSEMBLY


    A099198E02

  1. Remove the 2 bolts and disconnect the suction hose from the engine.



    G039332E03

  1. Disconnect the cooler compressor connector.

  1. Remove the 4 bolts and disconnect the compressor from the engine.

  1. Support the cooler compressor securely.



4. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET


    A099203E06

  1. Remove the 5 bolts and mounting bracket.



5. REMOVE CRANKSHAFT POSITION SENSOR


    A099147E04

  1. Disconnect the sensor connector.

  1. Disconnect the connector from the connector bracket.

  1. Detach the harness clamp.

  1. Remove the bolt and sensor.