CRANKSHAFT POSITION SENSOR > INSPECTION

for Preparation Click here



1. INSPECT CRANKSHAFT POSITION SENSOR


    A094922

  1. Measure the resistance between the terminals.

    Standard resistance:
    Temperature
    		Specified Condition
    Cold
    		1,630 to 2,740 Ω
    Hot
    		2,065 to 3,225 Ω

    NOTICE:
    In this table above, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately -10 to 50°C (14 to 122°F). "Hot" means approximately 50 to 100°C (122 to 212°F).

    If the resistance is not as specified, replace the sensor.