THROTTLE BODY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. DRAIN ENGINE COOLANT

  1. Remove the radiator cap.



  1. Loosen the 2 cylinder block drain cock plugs and radiator drain plug, and then the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A110401E01



3. REMOVE V-BANK COVER


    A112983

  1. Remove the 2 nuts and the V-bank cover.



4. REMOVE NO. 2 VENTILATION HOSE


A075594


5. REMOVE AIR CLEANER ASSEMBLY


    A075595

  1. Disconnect the vacuum hose.

  1. Disconnect the MAF meter connector.

  1. Remove the 2 wire harness clamps.



    A075596

  1. Loosen the 2 hose clamps.

  1. Remove the 2 bolts and air cleaner.



6. REMOVE THROTTLE BODY


    A075599

  1. Disconnect the throttle motor connector.

  1. Remove the 4 bolts and throttle body.

  1. Remove the gasket from the intake air surge tank.