ACCELERATOR PEDAL ROD > INSTALLATION

for Preparation Click here



1. INSTALL ACCELERATOR PEDAL ROD


    A099092E01

  1. Install the accelerator pedal rod with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the accelerator pedal position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


3. PERFORM INITIALIZATION

  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.