ECM > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


B086888E01

  1. Push in the sides of the glove compartment door, as indicated by the arrows in the illustration. Then open the door to release it from the 2 stoppers. Open the door until it is horizontal.



    B086887E02

  1. Pull the glove compartment door toward the rear of the vehicle to detach the 2 hinges and remove the glove compartment door.



3. REMOVE 4WD CONTROL ECU (for 4WD)


    A111702

  1. Disconnect the connector.

  1. Remove the bolt and 4WD control ECU.



4. REMOVE ECM


    A111703

  1. Disconnect the 4 connectors.

  1. Remove the bolt, 2 nuts and ECM.



5. REMOVE NO. 1 ECM BRACKET


    A111704

  1. Remove the 2 screws and bracket.



6. REMOVE NO. 2 ECM BRACKET


    A111705

  1. Remove the 2 screws and bracket.