CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


    A111696E01

  1. Measure the resistance between the terminals.

    Standard resistance:
    6.9 to 7.9 Ω at 20°C (68°F)

    If the result is not as specified, replace the oil control valve assembly.



    A099422E01

  1. Connect the battery's positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.

    Specified condition:
    Condition
    		Specified Condition
    Battery positive (+) voltage is applied
    		Valve moves in left arrow direction shown in the illustration
    Battery positive (+) voltage is cut off
    		Valve moves in right arrow direction shown in the illustration

    If the result is not as specified, replace the oil control valve assembly. If the valve cannot return properly because of foreign matter, a small pressure leak in the advanced direction may occur and a DTC may be output.