ENGINE COOLANT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR



A108624E01

  1. Partially soak the sensor in the water and warm up the water.

  1. Measure the resistance between the terminals.

    Standard resistance:
    Condition
    		Specified Condition
    Approx. 20°C (68°F)
    		2.32 to 2.59 kΩ
    Approx. 80°C (176°F)
    		0.310 to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.