OIL PUMP > INSTALLATION

1. INSTALL TIMING GEAR CASE ASSEMBLY

2. INSTALL OIL PAN SUB-ASSEMBLY

3. INSTALL OIL LEVEL GAUGE SUB-ASSEMBLY

4. INSTALL FUEL SUPPLY PUMP ASSEMBLY

5. INSTALL INJECTION GEAR

6. INSTALL CRANKSHAFT TIMING GEAR OR SPROCKET

7. INSTALL NO. 1 IDLE GEAR

8. INSTALL TIMING GEAR COVER

9. INSTALL CRANKSHAFT POSITION SENSOR

10. INSTALL CAMSHAFT POSITION SENSOR

11. INSTALL CRANKSHAFT PULLEY

12. INSTALL PUMP DRIVE SHAFT PULLEY

13. INSTALL VANE PUMP ASSEMBLY

14. INSTALL VACUUM PUMP ASSEMBLY

15. INSTALL WATER PUMP ASSEMBLY

16. INSTALL NO. 2 TIMING BELT COVER

17. INSTALL NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

18. INSTALL CAMSHAFT TIMING PULLEY

19. INSTALL CYLINDER HEAD COVER SUB-ASSEMBLY

20. INSTALL INJECTION PIPE

21. INSTALL FUEL INLET PIPE SUB-ASSEMBLY

22. INSTALL MANIFOLD STAY

23. INSTALL NO.1 COMPRESSOR MOUNTING BRACKET

24. INSTALL GENERATOR ASSEMBLY

25. INSTALL GENERATOR BRACKET

26. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY

27. INSTALL TIMING BELT

28. INSTALL NO. 1 TIMING BELT TENSIONER ASSEMBLY

29. INSTALL NO. 1 TIMING BELT COVER

30. REMOVE ENGINE FROM ENGINE STAND

31. INSTALL ENGINE ASSEMBLY

32. INSTALL REAR END PLATE

33. INSTALL FLYWHEEL SUB-ASSEMBLY

34. INSTALL PROPELLER SHAFT ASSEMBLY

35. INSTALL FRONT EXHAUST PIPE ASSEMBLY

36. INSTALL STARTER ASSEMBLY

37. INSTALL COOLER COMPRESSOR ASSEMBLY

38. CONNECT HOSES AND CONNECTORS

39. INSTALL RADIATOR ASSEMBLY

40. INSTALL AIR CLEANER ASSEMBLY

41. INSTALL BATTERY AND BATTERY TRAY

42. INSTALL BATTERY BRACKET

43. INSTALL RADIATOR GRILLE

44. INSTALL HOOD SUB-ASSEMBLY

45. ADD FUEL

46. TIGHTEN FUEL TANK CAP ASSEMBLY

47. ADD ENGINE COOLANT

48. ADD TRANSMISSION OIL

49. ADD ENGINE OIL

50. BLEED AIR FROM FUEL SYSTEM

51. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

52. PERFORM INITIALIZATION

53. CHECK FOR ENGINE OIL LEAKS

54. CHECK FOR ENGINE COOLANT LEAKS

55. CHECK FOR FUEL LEAKS

56. CHECK ENGINE OIL LEVEL

57. INSTALL NO. 2 ENGINE UNDER COVER (for 4WD)

58. INSTALL NO. 1 ENGINE UNDER COVER (for 4WD)