AUTOMATIC TRANSMISSION ASSEMBLY > INSTALLATION

1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

2. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY

3. INSTALL TRANSFER ASSEMBLY

4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

5. INSTALL FLYWHEEL HOUSING SIDE COVER

6. INSTALL STARTER ASSEMBLY

7. CONNECT WIRE HARNESS

8. CONNECT CONNECTOR

9. INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR

10. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

11. INSTALL NO. 1 TRANSMISSION CONTROL CABLE BRACKET

12. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

13. INSTALL OIL COOLER TUBE

14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

15. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

16. INSTALL NO. 2 MANIFOLD STAY

17. INSTALL MANIFOLD STAY

18. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

19. INSTALL EXHAUST PIPE

20. CONNECT HEATED OXYGEN SENSOR

21. INSTALL TRANSFER CASE LOWER PROTECTOR

22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

23. INSTALL TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

24. INSTALL SHIFT LEVER BOOT ASSEMBLY

25. INSTALL CONSOLE BOX ASSEMBLY

26. ADD AUTOMATIC TRANSMISSION FLUID

27. ADJUST AUTOMATIC TRANSMISSION FLUID

28. INSPECT SHIFT LEVER POSITION

29. PERFORM INITIALIZATION

30. CHECK FOR EXHAUST GAS LEAKS

31. INSTALL NO. 2 ENGINE UNDER COVER

32. INSTALL NO .1 ENGINE UNDER COVER