AUTOMATIC TRANSMISSION ASSEMBLY > INSTALLATION

1. INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY

2. INSTALL TORQUE CONVERTER CLUTCH ASSEMBLY

3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY

4. INSTALL FLYWHEEL HOUSING SIDE COVER

5. INSTALL STARTER ASSEMBLY

6. CONNECT WIRE HARNESS

7. CONNECT CONNECTOR

8. INSTALL NO. 1 ENGINE MOUNTING INSULATOR REAR

9. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

10. INSTALL NO. 1TRANSMISSION CONTROL CABLE BRACKET

11. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

12. INSTALL OIL COOLER TUBE

13. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

14. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

15. INSTALL NO. 2 MANIFOLD STAY

16. INSTALL MANIFOLD STAY

17. INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

18. INSTALL EXHAUST PIPE

19. CONNECT OXYGEN SENSOR

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

21. ADD AUTOMATIC TRANSMISSION FLUID

22. ADJUST AUTOMATIC TRANSMISSION FLUID

23. INSPECT SHIFT LEVER POSITION

24. PERFORM INITIALIZATION

25. CHECK FOR EXHAUST GAS LEAKS