MANUAL TRANSMISSION ASSEMBLY > REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

3. REMOVE UPPER CONSOLE PANEL ASSEMBLY

4. REMOVE CONSOLE BOX ASSEMBLY

5. REMOVE SHIFT LEVER BOOT ASSEMBLY

6. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY

7. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

8. REMOVE TRANSFER CASE LOWER PROTECTOR

9. REMOVE NO. 1 ENGINE UNDER COVER

10. REMOVE NO. 2 ENGINE UNDER COVER

11. DRAIN MANUAL TRANSMISSION OIL

12. REMOVE REAR PROPELLER SHAFT ASSEMBLY

13. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

14. REMOVE FRONT EXHAUST PIPE ASSEMBLY

15. DISCONNECT WIRE HARNESS

16. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (1KD-FTV, 2KD-FTV, 2TR-FE)

17. REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY (1GR-FE)

18. REMOVE STARTER ASSEMBLY

19. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

20. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR

21. REMOVE EXHAUST MANIFOLD STAY (2TR-FE)

22. REMOVE STIFFENER PLATE (1KD-FTV, 2KD-FTV)

23. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

24. REMOVE TRANSFER ASSEMBLY