MANUAL TRANSMISSION ASSEMBLY > INSTALLATION

1. INSTALL TRANSFER ASSEMBLY

2. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY

3. INSTALL STIFFENER PLATE (1KD-FTV, 2KD-FTV)

4. INSTALL EXHAUST MANIFOLD STAY (2TR-FE)

5. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR

6. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

7. INSTALL STARTER ASSEMBLY

8. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for 1KD-FTV, 2KD-FTV, 2TR-FE)

9. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY (1GR-FE)

10. CONNECT WIRE HARNESS

11. INSTALL FRONT EXHAUST PIPE ASSEMBLY

12. INSTALL REAR PROPELLER SHAFT ASSEMBLY

13. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

14. ADD MANUAL TRANSMISSION OIL

15. INSTALL NO. 2 ENGINE UNDER COVER

16. INSTALL NO. 1 ENGINE UNDER COVER

17. INSTALL TRANSFER CASE LOWER PROTECTOR

18. INSTALL TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

19. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY

20. INSTALL SHIFT LEVER BOOT ASSEMBLY

21. INSTALL CONSOLE BOX ASSEMBLY

22. INSTALL UPPER CONSOLE PANEL ASSEMBLY

23. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

25. PERFORM INITIALIZATION

26. CHECK SRS WARNING LIGHT

27. BLEED AIR FROM CLUTCH PIPE LINE (1GR-FE)

28. CHECK FOR CLUTCH FLUID LEAKAGE (1GR-FE)

29. INSPECT AND ADJUST CLUTCH PEDAL ASSEMBLY (1GR-FE)

30. CHECK FLUID LEVEL IN RESERVOIR (1GR-FE)