MANUAL TRANSMISSION ASSEMBLY > INSTALLATION

1. INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY

2. INSTALL STIFFENER PLATE (2KD-FTV)

3. INSTALL EXHAUST MANIFOLD STAY (for 1TR-FE)

4. INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR

5. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

6. INSTALL STARTER ASSEMBLY

7. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

8. CONNECT WIRE HARNESS

9. INSTALL FRONT EXHAUST PIPE ASSEMBLY

10. INSTALL REAR PROPELLER SHAFT ASSEMBLY

11. INSTALL NO. 2 FRAME CROSSMEMBER ASSEMBLY

12. ADD MANUAL TRANSMISSION OIL

13. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY

14. INSTALL SHIFT LEVER BOOT ASSEMBLY

15. INSTALL CONSOLE BOX ASSEMBLY

16. INSTALL UPPER CONSOLE PANEL ASSEMBLY

17. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

19. PERFORM INITIALIZATION

20. CHECK SRS WARNING LIGHT