AUTOMATIC TRANSMISSION ASSEMBLY > REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. REMOVE CONSOLE BOX ASSEMBLY

3. REMOVE SHIFT LEVER BOOT ASSEMBLY

4. REMOVE TRANSFER HIGH AND LOW SHIFT LEVER ASSEMBLY

5. REMOVE NO. 1 ENGINE UNDER COVER

6. REMOVE NO. 2 ENGINE UNDER COVER

7. REMOVE FRONT EXHAUST PIPE ASSEMBLY

8. REMOVE TRANSFER CASE LOWER PROTECTOR

9. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

10. REMOVE PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY

11. DRAIN AUTOMATIC TRANSMISSION FLUID

12. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY

13. DISCONNECT OIL COOLER TUBE

14. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

15. REMOVE TRANSMISSION CONTROL CABLE BRACKET

16. REMOVE STARTER ASSEMBLY

17. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY

18. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

19. DISCONNECT CONNECTOR

20. DISCONNECT WIRE HARNESS

21. REMOVE STIFFENER PLATE

22. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

23. REMOVE NO. 1 ENGINE MOUNTING INSULATOR REAR

24. REMOVE TRANSFER ASSEMBLY

25. REMOVE TORQUE CONVERTER CLUTCH ASSEMBLY