DTC    P0011/59    Camshaft Position "A" - Timing Over-Advanced or System Performance (Bank 1)

DESCRIPTION

MONITOR DESCRIPTION

WIRING DIAGRAM

INSPECTION PROCEDURE

When using intelligent tester:

PERFORM ACTIVE TEST (OPERATE OCV)

CHECK IF DTC OUTPUT RECURS (DTC P0011/59 OR P0012/59)

CHECK VALVE TIMING

CHECK ECM (OCV SIGNAL)

CHECK OIL CONTROL VALVE FILTER

INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (OCV)

REPLACE CAMSHAFT TIMING CONTROL VALVE ASSEMBLY (OCV)

CHECK CAMSHAFT TIMING GEAR ASSEMBLY

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY

CHECK FOR BLOCKAGE (OCV, OIL CHECK VALVE, OIL HOLE)

CHECK IF DTC OUTPUT RECURS (DTC P0011/59 OR P0012/59)

When not using intelligent tester:

CHECK VALVE TIMING

CHECK ENGINE SPEED (OPERATION OF OCV)

CHECK IF DTC OUTPUT RECURS (DTC P0011/59 OR P0012/59)

CHECK ECM (OCV SIGNAL)

CHECK OIL CONTROL VALVE FILTER

CHECK CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (OCV)

REPLACE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (OCV)

CHECK CAMSHAFT TIMING GEAR ASSEMBLY

REPLACE CAMSHAFT TIMING GEAR ASSEMBLY

CHECK FOR BLOCKAGE (OCV, OIL CHECK VALVE, OIL HOLE)

CHECK IF DTC OUTPUT RECURS (DTC P0011/59 OR P0012/59)