OIL PUMP > INSTALLATION

1. INSTALL TIMING CHAIN COVER OIL SEAL

2. INSTALL OIL FILTER BRACKET

3. INSTALL VVT SENSOR

4. INSTALL CYLINDER HEAD COVER LH

5. INSTALL CYLINDER HEAD COVER RH

6. INSTALL IGNITION COIL

7. INSTALL NO. 1 OIL PAN

8. INSTALL OIL STRAINER

9. INSTALL NO. 2 OIL PAN

10. INSTALL CRANKSHAFT PULLEY

11. INSTALL NO. 1 IDLER PULLEY

12. INSTALL NO. 2 IDLER PULLEY

13. INSTALL V-RIBBED BELT TENSIONER

14. INSTALL GENERATOR

15. INSTALL WATER INLET

16. INSTALL OIL DIPSTICK GUIDE

17. REMOVE ENGINE ASSEMBLY FROM STAND

18. INSTALL FLYWHEEL (for Manual Transmission)

19. INSTALL DRIVE PLATE AND RING GEAR ASSEMBLY (for Automatic Transmission)

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

21. PERFORM INITIALIZATION

22. ADD ENGINE OIL

23. ADD ENGINE COOLANT

24. CHECK FOR ENGINE COOLANT LEAKS

25. CHECK FOR FUEL LEAKS

26. CHECK FOR ENGINE OIL LEAKS

27. INSTALL V-BANK COVER

28. INSPECT IGNITION TIMING

29. INSPECT IDLE SPEED

30. INSPECT CO/HC