SERVICE DATA REFERENCE TABLE


1.Use the M.U.T.-III to check "Service Data."
note If a problem is found in the "Service Data" check, refer to the Check Trouble by Using the Input Signal Check (Refer to ).
2.The following input signals can be checked by using the M.U.T.-III.

INPUT SIGNALS WHICH CAN BE CHECKED BY SERVICE DATA


Input signals
 Item No.
 Item name
 Check condition
 Normal condition
LIN communication signal
 03
 Tail lamp
 When the column switch (lighting, wiper switch) is operated.
 ON when each switch is ON, and OFF when each switch is OFF
04
 Low beam lamp
05
 High beam lamp
06
 Turn signal lamp switch(LH)
07
 Turn signal lamp switch(RH)
08
 Automatic lamp
10
 Head lamp flasher
11
 Front wiper
12
 Front wiper interval
13
 Front wiper level 1 slow
14
 Front wiper level 2 fast
15
 Front wiper wash and wipe
16
 Tail wiper interval
17
 Tail wiper wash and wipe
18
 Variable interval signal
Digital signals
 19
 Driver’s door switch
 When the driver’s door is opened from the closed position
 From OFF to ON
20
 Driver’s door unlock switch
 Driver’s door: Locked to Unlocked
22
 All door switch (except driver’s door)
 When the door (except driver’s door) is opened from the closed position
23
 Front fog lamp switch
 When the switch is turned from OFF (not operated) to ON (operated)
24
 Rear fog lamp switch
25
 Windshield wiper auto stop signal
 When activated from the stopped condition
26
 Hazard warning lamp switch
 When the switch is turned from OFF (not operated) to ON (operated)
28
 Steering lock switch (Key reminder switch)
 Ignition key: Inserted to removed
29
 Ignition switch (ACC)
 When the ignition switch is turned from "LOCK" (OFF) to ACC
30
 Ignition switch (IG1)
 When the ignition switch is turned from "ACC" to "ON" position
Analogue signals
 31
 Battery voltage (IG1)
 When the ignition switch is turned from "ON" position
 System voltage
32
 Battery voltage (battery)
 Always
 System voltage
Internal timer data
 33
 Remain of front wiper dwell time
 When the windshield intermittent wiper interval adjusting knob is turned from SLOW to FAST
 Display changes between 0 - 32 seconds.
34
 Remain of rear wiper dwell time
 Always
 The intermittent time being set is displayed.(3 - 17 seconds)
42
 Speed class for front wiper
 The intermittent time setting of the front wiper is displayed.
 Classes from 0 to 3 are displayed.
43
 Variable int class for F/Wiper
 Classes from 0 to 5 are displayed.