CHECK TROUBLE BY USING THE INPUT SIGNAL CHECK



If a problem is found in the Service Data inspection, observe the table below.
Symptom
Inspection procedure number
Reference page
The column switch (lighting and wiper switch) signal is not received.
J-1

The ignition switch (ACC) signal is not received.
J-2

The ignition switch (IG1) signal is not received.
J-3

The hazard warning lamp switch signal is not received.
J-4

The front fog lamp switch signal is not received.
J-5

The rear fog lamp switch signal is not received.
J-6

The front door switch (LH) signal is not received. <COLT (LH drive vehicles)>
J-7

The front door switch (LH) signal is not received. <COLT CZ3 (LH drive vehicles)>

The front door switch (RH) signal is not received. <COLT (RH drive vehicles)>

The front door switch (RH) signal is not received. <COLT CZ3 (RH drive vehicles)>