Inspection Procedure 10: There is Noise but No Reception for LW/MW/FM or No Sound from LW/MW/FM.
DIAGNOSIS PROCEDURE
STEP 1. Check the state of the antenna.
Q.
Is the antenna assembled?
Go to Step 2.
Assemble the antenna.
STEP 2. Check to see if inspections are taking place is an area exposed to special electric fields.
Q.
Are inspections taking place under special electric field conditions (underground garage, inside a building, etc).?
Go to Step 3.
Go to Step 4.
STEP 3. Relocate and check.
Automatically receive in a good reception area that is not exposed to special electric fields.
Q.
Is reception of the strongest radio frequency possible within the area?
There is no action to be taken.
Go to Step 4.
STEP 4. Tune then check.
Q.
Did the sensitivity improve after tuning?
There is no action to be taken.
Go to Step 5.
STEP 5. Check the connection of the antenna plug and the radio with CD player.
Q.
Is the antenna plug thoroughly connected to the radio with CD player?
Go to Step 6.
Thoroughly connect the antenna plug and the radio with CD player.
STEP 6. Check by replacing the radio with CD player.
Q.
Are operations normal when using another radio with CD player?
Either repair or replace the radio with CD player.
Either repair or replace the antenna assembly.