Inspection Procedure 15: CD cannot be Inserted.

DIAGNOSIS PROCEDURE

STEP1. Check that a CD has been already loaded.

Q. Has a CD been already loaded?

Go to Step 2.

Take out the CD (If the CD cannot be ejected, refer to Inspection Procedure 19

). Check that a CD can be inserted.

STEP 2. Check how a CD is inserted.

Ensure that the ignition switch is at "ACC" or "ON".

note

If you try to load a CD when the ignition switch is at the positions other than "ACC" or "ON", the CD will not be inserted completely and then rejected.

Q. If you try to load the CD, does the CD stops halfway and then rejected?

Refer to Inspection Procedure 19

Go to Step 3.

STEP3. Check after the CD is loaded.

note

Even though the CD is loaded, "E" (error) is sometimes displayed with the CD rejected because of vibration/shock or dew on the CD face or optical lens.

Q. Though the CD is inserted completely, is "E" (error) displayed and the CD ejected?

Go to Step 4.

The procedure is complete.

STEP 4. Check the CD.

Check the CD for the conditions below:

Is the CD loaded with its label facing down?
Is the recorded face dirty or scratched?
Is there dew on the recorded face?

Q. Is the CD in good condition?

Go to Step 5.

The original CD is defective. Check that a CD can be inserted.

STEP 5. Check again using a normal CD, which is not dirty or scratched.

Load another normal CD.
Check that the CD player recognizes and play the CD.

Q. When you substitute another normal CD, is the CD loaded correctly?

The original CD is defective. Check that a CD can be inserted.

Replace the radio with CD player. The procedure is complete.