|
|
1.Check that the current tyre inflation pressures meet the inflation pressure label.
|
|
2.Set the vehicle to the speedometer tester, and set the rear wheels to the wheel chocks.
|
|
3.To stop operation of TCL/ASC, remove the fusible link box cover, and disconnect the TCL/ASC terminal connected to the fusible link (3). After disconnecting the TCL/ASC terminal, install the fusible link box cover, and wrap the disconnected terminal using tapes for insulation. <Vehicles with TCL/ASC>
|
|
4.For prevention of front wheel lateral runout, install the extension fitting on the front towing hook, and install both ends to the anchor plate.
|
|
5.For prevention of rear wheel lateral runout and vehicle sudden start, install the chain or wire (the other end of which is tightly fixed on rear towing hook) on the vehicle.
6.Check that the speedometer indicating range is within the standard value or the needle fluctuation is within the limit.
Standard value:
|
|
Speed km/h
|
Speedometer indicating range km/h
|
20
|
20.0 - 24.0
|
40
|
40.0 - 44.0
|
80
|
80.5 - 85.5
|
120
|
121.5 - 127.5
|
160
|
162..5 - 169.5
|
200
|
203.5 - 211.5
|
Speed MPH
|
Speedometer indicating range MPH
|
10
|
10.0 - 12.5
|
25
|
25.0 - 27.5
|
50
|
50.3 - 53.5
|
75
|
76.0 - 80.0
|
100
|
101.5 - 106.0
|
125
|
127.2 - 132.2
|
|
|
)
)
)
)