|
|
|
MAIN SWITCH
Switch position
|
Tester connection
|
Specified condition
|
FRONT (LH)
|
UP
|
7 - 10, 8 - 9
|
Continuity (Less than 2 Ω)
|
OFF
|
7 - 8, 8 - 9
|
DOWN
|
9 - 10, 7 - 8
|
FRONT (RH)
|
UP
|
10 - 12, 8* - 14
|
OFF
|
8* - 12, 8*- 14
|
DOWN
|
10 - 14, 8* - 12
|
|
| note |
*: Set the window lock switch to UNLOCK position.
|
|
|
|
|
SUB SWITCH
Switch position
|
Tester connection
|
Specified condition
|
UP
|
6 - 7, 4 - 5
|
Continuity (Less than 2 Ω)
|
OFF
|
7 - 8, 4 - 5
|
DOWN
|
4 - 6, 7 - 8
|
|
|
|
|
|
Tester connection
|
Slider position
|
- Connect terminal No.1 and the negative battery terminal.
- Connect terminal No.2 and the positive battery terminal.
|
UP
|
- Connect terminal No.2 and the negative battery terminal.
- Connect terminal No.1 and the positive battery terminal.
|
DOWN
|
|
|
|
|
1.Connect a battery directly to the motor terminals and check that the motor runs smoothly.
|
|
|
2.Check that the motor runs in the opposite direction when the battery is connected with the polarity reversed.
|
|
|
3.If defect is found, replace the window regulator as an assembly.
|
)
)
)