).| Check that the door window glass moves while contacting the door window glass runchannel when it is raised and lowered fully. If not, adjust the door window according to the following procedures. |
| 1.Remove the door trim assembly (Refer to GROUP 52A, Door trim ). |
| 2.Remove the waterproof film. (Refer to ). |
) |
3.Lower the door window glass until the door window glass mounting screw is visible in the hole. 4.Loosen the door window glass mounting screw from the hole. 5.Fully close the door window glass. 6.Lower the door window glass until the door window glass mounting screw is visible in the hole. 7.Fully tighten the door window glass mounting screw from the hole. |