STEERING ANGLE CHECK

caution After adjusting the steering angle, always perform calibration to make TCL/ASC-ECU learn the neutral position of the steering wheel sensor (Refer to GROUP 35C, On-vehicle Service - Steering Wheel Sensor Calibration ). <Vehicles with TCL/ASC>

1.Adjust toe-in (Refer to GROUP 33 - On-vehicle Service - Front Wheel Alignment Check and Adjustment ).

2.Place the front wheel on a turning radius gauge and measure the steering angle. Standard value: Inner wheel 36°40’ ± 1°30’ (Difference between right and left wheels must be 2°00’ or less) Outer wheel (reference value) 32°50’ 3.If not within the specification, replace the steering gear and linkage assembly (Refer to ).