).| 1.For vehicles with drum brake, remove the brake drum. |
| 2.For vehicles with disc brake, remove the caliper assembly, and suspend the caliper
assembly with a wire and remove the brake disc (Refer to ). |
) ) |
3.Check the bearing’s axial play. Place a dial gauge against the hub surface; then
move the hub in the axial direction and check whether or not there is axial play. Limit: 0.05 mm 4.If the play exceeds the limit, replace the rear hub assembly. 5.For vehicles with disc brake, after having checked, install the brake disc, the caliper assembly and tighten the caliper mounting bolt to the specified torque (Refer to ). |