TEACH IN CLUTCH TOUCH POSITION


AIM
The clutch touch point is related to the various information processing. When starting the engine for the first time after replacing the engine-A-M/T-ECU, clutch actuator, or clutch cover disk, perform the clutch touch position learning according to the following conditions and steps.

CONDITIONS

  • Ignition switch: ON
  • Engine: Start
  • Vehicle speed: 0 km/h
  • Automated manual transmission control relay: ON
  • Battery voltage: 9 V or more
  • Allshift lever position: N (Shift range: neutral)
  • Transmission assembly or input speed sensor: No malfunction
  • Clutch actuator: No malfunction

1.
caution Before connecting or disconnecting the M.U.T.-III, turn the ignition switch to the "LOCK" (OFF) position.
Connect the M.U.T.-III to the diagnosis connector.
2.Turn the ignition switch to the ON position.
3.Select "POWER TRAIN."
4.Select "Automated-M/T."
5.Select "Special Function."
6.Select "Clutch."
7.Select "Teach In Clutch Touch Position" on "Special Function Command" to perform the learning.
8.After completion of the learning, terminate the M.U.T.-III and turn the ignition switch to LOCK (OFF) [Turning OFF the automated manual transmission control relay].
9.Remove the M.U.T.-III.