Item No.
|
Inspection item
|
Drive content
|
Inspection conditions
|
Normal condition
|
Code No. /Inspection procedure No.
|
Reference page
|
1
|
Injector
|
Cut off No. 1 injector
|
Engine: After warm-up, idle operation
(Cut off injectors sequentially to check for a cylinder that does not change engine in idle
status.
|
Engine is changed (becomes unstable or stalled)
|
Code No. P0201
|
|
2
|
Cut off No. 2 injector
|
Code No. P0202
|
|
3
|
Cut off No. 3 injector
|
Code No. P0203
|
|
5
|
Fuel pump
|
Drive fuel pump to circulate fuel
|
Ignition switch: "ON"
|
Check for pump operating noise near fuel tank
|
Operating noise audible
|
Procedure No. 30
|
|
6
|
Purge control solenoid valve
|
Switch solenoid valve from OFF to ON
|
Ignition switch: "ON"
|
When the valve is actuated, operating noise is audible
|
Code No. P0443
|
|
7
|
Basic ignition timing
|
Switch Engine-ECU to ignition timing adjusting mode
|
- Engine: Idle operation
- Install timing light
|
5° BTDC
|
-
|
-
|
8
|
Radiator fan (Hi)
|
Drive the fan motor at high speed
|
Ignition switch: "ON"
|
Fan motor operates at high speed
|
Procedure No. 21
|
|
9
|
Radiator fan (Low)
|
Drive the fan motor at low speed
|
Ignition switch: "ON"
|
Fan motor operates at low speed
|
Procedure No. 21
|
|
10
|
Throttle valve control servo*
|
Stop the throttle valve control servo
|
Ignition switch: "ON"
|
Throttle valve is open slightly
|
Code No. P0638
|
|
13
|
A/C compressor relay
|
Switch the A/C compressor relay from OFF to ON
|
Ignition switch: "ON"
|
The operating sound of A/C compressor is audible
|
Procedure No. 31
|
|
14
|
Capacitor relay <Vehicles with AS&G system>
|
Switch the capacitor relay from OFF to ON
|
- Disconnect the connectors of the engine-ECU.
- Connect the special tool power plant ECU check harness (MB991987) between the disconnected connectors.
- Ignition switch: "ON"
|
Measure the voltage between the earths of the terminal No.135. - Confirm
the voltage is less than 1 V during the actuator test.
|
GROUP 54A - Radio With CD Player - Symptom Procedures - Inspection Procedure No.
2
|
|