THROTTLE VALVE CONTROL SERVO CHECK


OPERATION CHECK
warning When checking the throttle valve operation, never insert fingers into the throttle valve. The extremely strong power of the throttle valve motor might trap and injure fingers.
1.Remove the air intake hose from the throttle body.
2.Turn the ignition switch to "ON" position.
3.Operate the accelerator pedal and confirm that the throttle valve is opening and closing accordingly.

CHECK THE COIL RESISTANCE
warning When touching the throttle valve, surely shut off the driving circuits of the throttle valve. In the event that throttle valve is operated, a finger might be injured as the result of being caught by the throttle valve.

1.Disconnect the electronically controlled throttle valve connector.
2.Measure the resistance between terminals No. 1 and No. 2 at the electronically controlled throttle valve connector.
Standard value: 0.3 - 100 Ω (at 20°C)
note If the measured resistance deviates from the standard value, fully open the throttle valve with your finger more than five times, then check the result again. If the throttle valve control serve is not used for an extended period of time, the resistance may be increased as a result of internal forming of oxide film. Therefore, it means that the oxide film can be removed through a self cleaning capability of the throttle valve control servo, if forcibly moved.
3.If resistance is outside the standard value, replace the throttle body assembly.