THROTTLE BODY (THROTTLE VALVE AREA) CLEANING

warning

When touching the throttle valve, surely shut off the driving circuits of the throttle valve. In the event that the throttle valve is operated, a finger might be injured as the result of being caught by the throttle valve.

caution

When throttle body is cleaned, the idling learning in MPI engine is reguired (Refer to GROUP 00, Precautions Before Service - Learning Procedure for Idling in MPI Engine

1.Disconnect the electronic-controlled throttle valve connector.

2.Remove the air intake hose from the throttle body.

3.Remove the throttle body assembly.

caution

Do not spray the cleaning fluid directly to the throttle valve.
Make sure the cleaning fluid does not enter the motor from the bypass line. Also make sure it does not enter the sensor through the shaft.

4.Spray cleaning fluid on a clean cloth.

5.Wipe off the dirt around the throttle valve with the cloth sprayed with cleaning fluid.

6.Install the throttle body assembly.

7.Attach the air intake hose.

8.Connect the electronic-controlled throttle valve connector.