OIL PRESSURE CHECK


1.Check engine oil quantity.
caution Since sealant is applied to the thread of oil pressure switch, take care not to damage the oil pressure switch when removing it.


2. Remove the oil pressure switch.
3. Install the oil pressure gauge.
note Use an adapter of PT 1/8 thread.
4.Run the engine to warm it.
5.After the engine has been warmed up, check that oil pressure is within the standard value.
Standard value:
    At idle: 29 kPa or more
    At 3,500 r/min: 294 - 686 kPa
6.Remove the oil pressure gauge.

7.Apply the specified sealant to the thread of oil pressure switch.
Specified sealant:
    LOCTITE 565 or equivalent <134, 135>
    Three bond 1215 or equivalent <3A9, 4A9>
    Three bond 1207F or equivalent <4G1>
caution Do not start the engine within one hour after the oil pressure switch has been installed.
8.Tighten the oil pressure switch to the specified torque.
Tightening torque: 10 ± 2 N·m