|
|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches
80 °C to 90 °C.
|
|
|
2.
| warning |
Use care as oil could be hot.
|
Remove the engine oil filler cap.
|
|
|
3.Remove the drain plug to drain oil.
|
|
4.As for 134, 135 or 4G1 engine, remove the engine oil filter using the commercially-available
tool.
As for 3A9 or 4A9 engine, remove the engine oil filter using the oil filter wrench (Special
tool: MB991396).
5.Clean the filter bracket side mounting surface.
|
|
6.Apply a small amount of engine oil to the O-ring of the new oil filter.
7.Where the oil filter O-ring touches the oil pan flange, tighten the oil filter to
the specified torque using the commercially-available tool or special tool.
|
|
Engine
|
Number
|
Tightening torque
|
134, 135
|
MR984204
|
Approximately 3/4 turn (11 ± 1 N·m)
|
3A9, 4A9
|
MD360935
|
Approximately 1 turn (14 ± 2 N·m)
|
4G1
|
MD136466, MD322508
|
Approximately 3/4 turn (17 ± 3 N·m)
|
MD356000
|
Approximately 3/4 turn (14 ± 2 N·m)
|
|
8.Install the drain plug and refill the engine oil (Refer to  <134,
135>, <3A9, 4A9>, <4G1>).
9.Rev the engine a few times, and check to be sure that no engine oil leaks from the
installation section of the oil filter.
|
)
)