|
|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches
80 °C to 90 °C.
|
|
|
2.
| warning |
Use care as engine oil could be hot.
|
Remove the engine oil filler cap.
|
|
|
3.Remove the engine oil pan drain plug to drain engine oil.
|
|
4.Install a new engine oil pan drain plug gasket so that it faces in the direction shown
in the illustration, and then tighten the engine oil pan drain plug to the specified torque.
Tightening torque: 39 ± 5 N·m
|
|
5.Refill with specified quantity of engine oil.
Specified Engine Oil
- ACEA classification: A1/B1, A3/B3, A3/B4 or A5/B5 <Clear
Tec>
- ILSAC classification: ILSAC certificated oil <Clear Tec>
- API classification: SG or higher <Clear Tec>
- MB 229.1 or higher <Except for Clear Tec>
Total quantity (Includes volume inside engine oil filter):
| note |
FOR Clear Tec models SAE 0W-20, 0W-30, 5W-30, and 5W-40 engine oils can only be used if
they meet ACEA A3/B3, A3/B4 or A5/B5 and API SG (or higher) specifications.
|
6.Install the engine oil filler cap.
7.Check engine oil level.
|
)
)