ENGINE OIL REPLACEMENT <134, 135>


1.Start the engine and allow it to warm up until the temperature of the coolant reaches 80 °C to 90 °C.
2.
warning Use care as engine oil could be hot.
Remove the engine oil filler cap.
3.Remove the engine oil pan drain plug to drain engine oil.
4.Install a new engine oil pan drain plug gasket and then tighten the engine oil pan drain plug to the specified torque.
Tightening torque: 55 ± 5 N·m

5.Refill with specified quantity of engine oil.
Specified Engine Oil :MB 229.1 or higher
Total quantity (Includes volume inside engine oil filter):

    <134> 3.2 L
    <135> 4.2 L
6.Install the engine oil filler cap.
7.Check engine oil level.