INSPECTION


CAMSHAFT

Measure the cam height. If the measured value exceeds the limit, replace the camshaft.
Standard value:
    Intake 44.81 mm
    Exhaust 43.98 mm
Limit:
    Intake 44.31 mm
    Exhaust 43.48 mm

VALVE TAPPET



1.Measure the valve tappet at the illustrated location. If the measured valve is discord to instruction valve by identification mark and following table, replace the tappet.

2.Every valve tappet has an identification mark stamped at the illustrated location.
Valve tappets are available in 31 sizes, at 0.02 mm intervals in the 2.70 - 3.30 mm range, as shown in the following table.
Thickness mm
 ID mark
Thickness mm
 ID mark
Thickness mm
 ID mark
2.70
 70
2.92
 92
3.14
 14
2.72
 72
 2.94
 94
 3.16
 16
2.74
 74
 2.96
 96
 3.18
 18
2.76
 76
 2.98
 98
 3.20
 20
2.78
 78
 3.00
 00
 3.22
 22
2.80
 80
 3.02
 02
 3.24
 24
2.82
 82
 3.04
 04
 3.26
 26
2.84
 84
 3.06
 06
 3.28
 28
2.86
 86
 3.08
 08
 3.30
 30
2.88
 88
 3.10
 10
2.90
 90
 3.12
 12