)
| 1.Before inspection, set the vehicle to the pre-inspection condition. |
|
2.Turn the ignition switch to the "LOCK" (OFF) position and then connect the M.U.T.-III
to the diagnosis connector. |
) |
3.Attach a three-way joint to the vacuum hose between the fuel pressure control solenoid
valve and the inlet manifold, and connect a vacuum gauge. 4.Start the engine and check that idle speed is within the standard valve. Standard value: 750 ± 100 r/min 5.Check the inlet manifold vacuum. Limit: Minimum 60 kPa 6.Turn off the ignition switch. 7.Remove the vacuum gauge and the three-way joint, and then connect the vacuum hose. 8.Turn the ignition switch to the "LOCK" (OFF) position and then disconnect the M.U.T.-III. |