1. Measure the voltage at each terminal (other than terminals G and H).
2. Disconnect the negative battery cable.
3. Inspect the power window subswitch connector for continuity at terminals G and H.
4. If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch.
|
Terminal
|
Signal name
|
Connected to
|
Measured condition
|
Voltage (V)/Continuity
|
Inspection item(s)
|
|---|---|---|---|---|---|
|
A
|
Pulse 1
|
Power window motor
|
Door glass moving
|
Alternates between 1.0 or less and B+.
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
Door glass stopped
|
1.0 or less or B+
|
||||
|
B
|
Power supply
|
P/WIND R 30 A fuse (RH) P/WIND L 30 A fuse (LH)
|
Under any condition
|
B+
|
• P/WIND R 30 A fuse (RH) P/WIND L 30 A fuse (LH)
• Related wiring harnesses
|
|
C
|
Communication
|
Power window main switch
|
-
|
-
|
-
|
|
D
|
Close output
|
Power window motor
|
While door glass is opening
|
1.0 or less
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
While door glass is closing
|
B+
|
||||
|
E
|
Pulse 2
|
Power window motor
|
Door glass moving
|
Alternates between 1.0 or less and B+.
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
Door glass stopped
|
1.0 or less or B+
|
||||
|
F
|
Open output
|
Power window motor
|
While door glass is opening
|
B+
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
While door glass is closing
|
1.0 or less
|
||||
|
G
|
Sensor ground
|
Power window motor
|
Under any condition: Inspect for continuity to ground.
|
Continuity detected
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
H
|
GND
|
Body ground
|
Under any condition: Inspect for continuity to ground.
|
Continuity detected
|
• GND
|
|
I
|
Power supply
|
Power window motor
|
Ignition switch at ON
|
B+
|
• Power window motor (See POWER WINDOW MOTOR INSPECTION.)
• Related wiring harnesses
|
|
L
|
Power-cut signal
|
Power window main switch
|
Ignition switch at ON and power-cut switch at UNLOCK
|
B+
|
• Power window main switch (See POWER WINDOW MAIN SWITCH INSPECTION.)
• Related wiring harnesses
|