NO.30 DOES NOT DOWNSHIFT IN M RANGE


30	Does not downshift in M range
DESCRIPTION	• Gear position indicator light in instrument cluster illuminates, but the vehicle does not downshift when the selector lever is pushed to "-" side.
POSSIBLE CAUSE	• Down switch or related wiring harness malfunction Note • Before following the troubleshooting steps, make sure that the Automatic Transaxle On-board Diagnostic and Automatic Transaxle Basic Inspection are conducted.


STEP	INSPECTION		ACTION
1	Inspect the DWN SW PID value using the WDS or equivalent. (See PCM INSPECTION [ZJ, Z6].) (See PCM INSPECTION [LF].) Is the DWN SW PID value normal?	Yes	Inspect the instrument cluster.
1		No	Inspect the down switch. If the down switch is normal, inspect for continuity between the down switch and PCM terminal 1AB.
2	• Verify the test results. - If normal, return to the diagnostic index to service any additional symptoms. - If the malfunction remains, inspect the related Service information and perform repair or diagnosis. • If the vehicle is repaired, troubleshooting is completed. • If the vehicle is not repaired or additional diagnostic information is not available, replace the PCM.