BATTERY REMOVAL/INSTALLATION [LF]

B3E011718520W02

1. Remove in the order indicated in the table.

Note

• Remove the parts 8 to 11 in the table if necessary.

2. Install in the reverse order of removal.


1	Battery cover (See Battery Cover Installation Note.)
2	Negative battery cable
3	Positive battery cable
4	Battery duct (See Battery Duct Installation Note.)
5	Battery box (See Battery Box Installation Note.)
6	Battery clamp
7	Battery
8	Set bolt (See Set Bolt Removal Note.) (See Set Bolt Installation Note.)
9	PCM cover (See PCM Cover Installation Note (L.H.D.).) (See PCM Cover Installation Note (R.H.D.).)
10	Connectors
11	Battery tray and PCM component

Set Bolt Removal Note

1. Drill the set bolts using a drill bit with a diameter larger than the shanks until the heads are removed.

• If the shanks remain, remove them using locking pliers.

2. Clean all foreign material from the PCM connectors.

1. Install with the PCM cover hooks B aligned with the PCM box holes.

2. Install the PCM cover to the PCM box hook.

1. Insert the tab of the PCM cover to the hole.

2. Rotate until the area F is paralleled. The harness and the PCM cover should be located at the area G.

1. Install new set bolts and temporarily tighten them first, then tighten them until the necks of the bolts break off.

1. Assemble with the battery box hooks E aligned with the battery tray holes at two points.

1. Match the mark of the shroud panel and notch in the battery duct, and install the battery duct to the shroud panel.

1. Install the battery duct between the battery cover and the battery box.

2. Install with the battery cover hooks A aligned with the battery tray holes at two points.

3. Install with the battery cover hooks D aligned with the battery tray flange at two points.

4. Set the battery cover to the battery tray hooks C at two points.