Diagnostic procedure
|
STEP
|
INSPECTION
|
RESULTS
|
ACTION
|
|---|---|---|---|
|
1
|
Connect the WDS or equivalent to the DLC-2.
Access ECT PID.
Start and warm-up the engine to normal operating temperature.
Is ECT PID between 82-112°C {180-234°F}?
|
Yes
|
Go to the next step.
|
|
No
|
ECT PID is more than 112°C {234°F}:
Go to symptom troubleshooting "No.17 Cooling system concerns - Overheating".
ECT PID is less than 82°C {180°F}:
Go to symptom troubleshooting "No.18 Cooling system concerns - Runs cold".
|
||
|
2
|
Connect the WDS or equivalent to the DLC-2.
Retrieve any continuous memory DTCs.
Are there any DTCs displayed?
|
Yes
|
DTC is displayed:
Go to the appropriate DTC inspection.
(See DTC TABLE [ZJ, Z6].)
|
|
No
|
No DTC is displayed:
Go to the next step.
|
||
|
3
|
Connect the WDS or equivalent to the DLC-2.
Access AC_REQ, CPP, CPP/PNP, TR and PSP PIDs.
Monitor each PID.
(See PCM INSPECTION [ZJ, Z6].)
Are PIDs normal?
|
Yes
|
Go to the next step.
|
|
No
|
AC_REQ PID:
Inspect the A/C switch, refrigerant pressure switch and fan switch.
CPP PID:
Inspect the clutch pedal position switch (MTX).
CPP/PNP PID:
Inspect the neutral switch (MTX).
TR PID:
Inspect the TR switch (ATX).
PSP PID:
Inspect the PSP switch.
|
||
|
4
|
Is there air leakage felt or heard at the intake-air system components while racing the engine to higher speed?
|
Yes
|
Repair or replace part if necessary.
|
|
No
|
Verify accelerator cable free play.
|
||
|
5
|
Verify test results.
• If normal, return to diagnostic index to service any additional symptoms.
• If malfunction remains, inspect related Service information perform repair or diagnosis.
|
||