Steering Rack Guide Replacement
Manufactored in except HATC
NOTE: During removal/installation, do not allow dust, dirt, or other foreign materials to enter the gearbox.
| 1. | Loosen the locknut (A), then remove the rack guide screw (B), conical springs (C), holder (D), needle roller (E), and roller (F) from the steering gearbox.
 ABCDEFGPortugal model: |
| 2. | Grease the inside of holder and the sliding surface and circumference of the roller.
|
| 3. | Install the roller, the needle roller, and the holder onto the gearbox housing. Wipe the grease off the threaded section (G) of the housing.
|
| 4. | Install the conical springs onto the holder.
NOTE: Make sure the number of the conical springs and the direction when installing.
|
| 5. | Apply sealant to the threads on the rack guide screw, then install and tighten it to 25 N·m (2.5 kgf·m, 18 lbf·ft). Loosely install the locknut.
|