Power Window Master Switch Test
Power Window Master Switch Test
| 1. | Remove the power window master switch. |
| 2. | Disconnect the 20P connector from the switch.
 |
Driver's Switch:
The driver's switch is combined with the control unit so you cannot isolate the switch to test it.
Instead, run the master switch input test procedures on page 22-122. If the tests if the tests are normal, the driver's switch must be faulty.
Front passenger's Switch:
PositionTerminalMainSwitchOFFOFFONOFFONONOFFUPDOWN1238[9][8][7][2]
Left Rear Switch:
PositionTerminalMainSwitchOFFOFFONOFFONONOFFUPDOWN1918178[2]
Right Rear Switch:
PositionTerminalMainSwitchOFFOFFONOFFONONOFFUPDOWN1211108[2][ ]: RHD type
| 3. | If the switch is faulty, replace the switch. |