Alternator Replacement (With ETCS)
Alternator Replacement
| 1. | Disconnect the battery negative cable from the battery. |
| 2. | Remove the intake manifold. |
| 3. | Disconnect the alternator connector (A), WHT wire (B) and harness clamp (C) from the alternator.
 6 x 1.0 mm8 N·m (0.8 kgf·m, 6 lbf·ft)ABC |
| 4. | Remove the drive belt. |
| 5. | Remove the lock bolt (A) and mounting bolt (B), then remove the alternator.
 B10 x 1.25 mm 44 N·m (4.5 kgf·m, 33 lbf·ft)A 8 x 1.25 mm 24 N·m (2.4 kgf·m, 17 lbf·ft) |
| 6. | Install the alternator in the reverse order of removal. |
| 7. | Adjust the drive belt tension. |
| 8. | Perform the ETCS learn procedure (with ETCS). |