Honda Jazz/Fit 2003 · Service Manual

VTEC Rocker Arms Test (L15A)

VTEC Rocker Arms Test

Special Tools Required
Valve inspection set (  07LAJ-PR30102)
 

S5A3E00SLAJPR3T0102000D01
VTEC air adapter (  07VAJ-P8A010A)
 
SEY3J00SVAJP8AT010A000D01
VTEC air stopper (  070AJ-0030100)
 
SDA3A00S0AJ003T0100000D01
VTEC adapter (  070AJ-0010100)
 
SEY3J00S0AJ001T0100000D01



1.Warm up the engine for 5 minutes.

2.Remove the cylinder head cover..

3.Rotate the crankshaft clockwise, and visually check all the primary rocker arms and secondary rocker arms moves freely.

  • If the primary rocker arm and secondary rocker arm moves together, remove the primary and secondary rocker arms as an assembly, and check that the pistons in the primary and secondary rocker arms move smoothly. If any rocker arm needs replacing, replace the primary and secondary rocker arms as an assembly, and test.
  • If all the primary rocker arms and secondary rocker arms moves freely, go to 4.

4.Check that the air pressure on the shop air compressor gauge indicates over 400 kPa (4 kgf/cm2, 57 psi).

5.Inspect the valve clearance.

6.Remove the No. 3 rocker shaft mounting bolt, then install the VTEC air adapter (A) with a washer (thickness about 1.5 mm (0.06 in. )).

 

SAA3EB0A14666351511FEAD01D
07LAJ-PR30102B
070AJ-0030100A
07VAJ-P8A010AC
070AJ-0010100

7.Remove the No. 5 rocker shaft mounting bolt, then install VTEC air stopper (B).

8.Install the VTEC adapter (C) to the VTEC air adapter, then connect the valve inspection set (D).

9.Loosen the valve on the regulator, and apply the specified air pressure.

Specified Air Pressure:
340 kPa (3.5 kgf/m2, 50 psi) 


10.With the specified air pressure applied, rotate the crankshaft clockwise, and visually check all the primary rocker arms and secondary rocker arms should move together.

  • If the primary rocker arm and secondary rocker arm moves freely, remove the primary and secondary rocker arms as an assembly, and check that the pistons in the primary and secondary rocker arms move smoothly. If any rocker arm needs replacing, replace the primary and secondary rocker arms as an assembly, and test.

11.Remove the special tools.

12.Apply engine oil to the bolt threads and flange of the rocker shaft mounting bolts, then tighten the bolts to 29 N·m (3.0 kgf·m, 22 lbf·ft)

13.Install the cylinder head cover.