M/T Countershaft Bearing Replacement (5MT)

M/T Countershaft Bearing Replacement

Special Tools Required
Adjustable bearing puller, 25-40 mm (  07JAC-PH80100)
 

Bearing remover shaft (  07JAC-PH80200)
 Slide hammer (  07741-0010201)
 Driver (  07749-0010000)
 Attachment, 52 x 55 mm (  07746-0010400)
 

1.	Remove the needle bearing (A) using the special tool, then remove the oil guide plate C.   07JAC-PH8020007741-001020107JAC-PH80100CA

2.	Position the oil guide plate C and new needle bearing (A) in the bore of the clutch housing (B).   07749-001000007746-0010400BAC

3.	Install the needle bearing using the special tools.