Instrument Visor Removal/Installation

Instrument Visor Removal/Installation

NOTE:

• Do not pry the visor or panel surface with a flat-tip screwdriver to prevent damage.
  
• Take care not to scratch the dashboard and related parts.
  
• LHD is shown, RHD is symmetrical.
  

1.	Tilt the steering column down.

2.

Remove the instrument panel (A): -1  Gently pull out along the bottom to release the hooks (B), and ribs (C) from the clips (D) of the instrument lower visor (E). -2  Gently pull out the upper portion of the panel to detach the hooks (F) and clips (G, H).   Fastener Locations: Clip, 2D: Clip, 2G: Clip, 2HAEFBCBFHBDDHGG

3.	Remove the instrument lower visor (A): -1  Remove the screws (B). -2  Gently pull out along the top to release the clips (C).   Fastener Locations: Screw, 4B: Clip, 5CACBCCBBBCC

4.	Remove the screws, then remove the instrument upper visor (A).   Fastener Locations: Screw, 5A

5.	Install the visors and panel in the reverse order of removal. Push the clip portions into place securely.