Glossary
|
6-20 | |||
| Lacquer | A type of pain that uses cellulose nitrate or other chemicals and dries by evaporation of its solvent agent. | ||
| Meramine resin | Used as component for aminoalkyd resin paint and heat-hardening acrylic resin paint. | ||
| Metallic-base paint | Paint with aluminium power for metallic tone. | ||
| Mist coat | Painting for fade-in sections. A small amount of paint may be dissolved with slow-evaporating thinner, or thinner alone may be applied with low pressure.
150-200kPa (1.5-2.0kgf/cm², 21.3-28.4 psi) |
||
| Mixing scale | Colour mixing device. | ||
| Overlap | Blending of spray patterns. | ||
| Overspray | Spraying other than the area that needs painting. | ||
| Paddle | A tool to mix paint. | ||
| Paint dust | Dust of paint formed by spraying. | ||
| Paper dispenser | A paper posting device (masker) that combines tape and paper. | ||
| Scrapes | Traces of scratches. | ||
| Scuffing | Particles on the painted surface are lightly polished with fine emery paper (#600 or over). | ||
| Set (setting) | Evaporation time of solvent in the paint, before drying the layer forcefully or by banking. (May be considered the same as flash-off time). | ||
| Single coat | Application of paint in single layer. | ||
| Spot paint | Painting of small section, such as for touch-up. | ||
| Undercoat | Undercoat paint (such as primer and surface).
May be applied to lower section of car for moist prevention and rust proofing. |
||