- Apply a bead (A) of liquid gasket to sealing surfaces of crankshaft seal ring retainer (B).
- Install crankshaft seal retainer to rear of cylinder block.
Specified torque:
9.8 Nm (1.0 kgf/m, 7.2 lbf/ft)
NOTE: Recut thread before re-use and insert bolts with screw locking compound. The installation time including the torque check is max. 10 min.
- Apply engine oil to oil seal lip.
- Install oil seal to oil seal retainer using special tool (5-8840-7005-0; without crankshaft or 5-8840-7006-0; with crankshaft).
Special Tool Required
Aligner 5-8840-9054-0
- Clean the sealing surfaces of the upper oil pan and remove the sealant residue.
- Apply a bead of liquid gasket to sealing surfaces on the oil pan upper.
- Install aligner (special tool) (A) (5-8840-9054-0) to oil pan upper with tightening torque 9.8 Nm (1.0 kgf/m, 7.2 lbf/ft).
