- Lower the hoist.
- Install the upper bracket (A), then tighten the bolt/nut in the numbered sequence shown.
- Install the ground cable (B).
- Tighten the support bolt and nuts.
- Remove the chain hoist from the engine.
- Raise the hoist to full height.
- Install a new spring clip on the end of each driveshaft, then install the driveshafts. Make sure each clip ''clicks'' into place in the differential and intermediate shaft.
- Connect the suspension lower arm ball joints, refer to the '01 Civic Shop Manual on this CD (see step 3 on page 18-19).
- Connect the stabiliser links, refer to the '01 Civic Shop Manual on this CD (see page 18-18).
- Install the exhaust pipe A/three way catalytic converter (TWC) assembly (A); use new gaskets (B) and new self locking nuts (C).
