- Measure the inside diameter of bearing on the rear cover. If measurement is more than limit, replace the rear cover assembly.
Inside diameter:
Standard:
12.018 – 12.029 mm
(0.4731 – 0.4736 in.)
Limit:
12.129 mm (0.4775 in.)
- Measure the inside diameter of the centre bracket (p). If measurement is more than limit, replace the centre bracket (P).
Inside diameter:
Standard:
18.035 – 18.060 mm
(0.7100 – 0.7110 in.)
Limit:
18.160 mm (0.7150 in.)
- Measure the inside diameter of bearing on the pinion shaft. If measurement is more than limit, replace the pinion shaft.
Inside diameter:
Standard:
6.725 – 6.77mm (0.2648 – 0.2665 in.)
Limit:
6.87 mm (0.2705 in.)
